Category: Printer Settings

MadeSolid printing information

The MadeSolid resins are created to not be limited to one single printer, however have good results with many SLA and DLP printers. The material properties include a unique matt finish, less viscosity and easier to clear from the vat. The improved V2 MS Resin shows the following upgrades: •… Read More»

MadeSolid CastSolid printing information

How CastSolid burns out CastSolid has two burn stages which are necessary for the cleanest burnout. The first phase, at 540F, is the initial combustion of the resin where the majority of material is removed. The second phase is at 1350F, which serves to remove any residual carbon from the… Read More»

ColorFabb PLA/PHA printer settings

Here are some tips and tricks on how to use ColorFabb 3d printing filament. Advised 3d printing temperature: 195-220C* Advised 3d print speed: 40 – 100 mm/s Advised Heated bed (if you have one, not strictly necessary): 50-60C Build platform The PLA/PHA filament performs well on both heated and non-heated build platforms. For… Read More»

B9 Creator Printing information

The B9 Red and B9 Cherry are both the same resin. The Cherry has more pigment though and will print at a higher resolution and therefore has better detail. The B9 Red is pigmented for 75-100 micron layer thickness. The B9 Cherry is pigmented for 25-50 micron layer thickness. Dimensions… Read More»

ProtoPasta Carbon Fibre PLA printer settings

  ProtoPasta Carbon Fiber PLA is made from NatureWorks 4043D PLA Resin compounded with 15% by weight chopped Carbon Fibers. The filament is moisture sensitive and should be kept bagged with desiccant . This filament is quite brittle and care should be taken in handling and feeding your 3D printer. It… Read More»